Manufacturer: Triplett

Part#: 3399

 

The Triplett Fox 2 and Hound 3 Kit contains a deluxe tone generator and tracer. This kit aids in identifying, locating and tracing wires, cables and other conductors. When the Fox 2 is used to apply a "tone" to a wire, the Hound 3 can be used to locate the wire inside of, or behind electrically non-conductive surfaces (plastic, wood, drywall, etc.) up to 12 inches away.

Includes

• Fox 2 Deluxe Tone Generator
• Hound 3 Probe Inductive Tracer
• Cordura Carrying Case

The Fox 2: Deluxe Tone Generator with “TrueTrace”

• Overload Protected - 120VAC Line Cross Protection on all Functions
• Overload Warning Beeper - alerts user to potential hazards
• Warble/Pulse Tracer Tone - Selectable tone for audible & visual ID using Hound, Hound 2 or Hound 3 Probe Inductive Tracers
• High Output Tracer Tone
• Generates 2 of 6 User Selectable Tracer Tones
• Internal User Selectable Settings - HI/LO Pitch Shift, Warble/Continuous Tracer Tone, On/Off Audio Pilot Tone, On/Off Cadence Shift
• Tone/Battery LED - indicates that Tracer Tone is on and battery is OK
• Audio Pilot Tone - confirms the Tracer Toner signal
• Visual & Audible Continuity Test
• Red/Green Telephone Line Polarity LEDs - also indicates AC/RING Signal
• Supplies “Talk Power” to allow communicating between handsets (talksets) or powering a telephone
• Line powered in Tone Mode
• Built in Telephone Ringer
• “Power Latch” - prevents accidental turn-ons maximizing battery life
• Magnetic Back - stick the Fox 2 to steel surfaces
• Works with Hound, Hound 2 or Hound 3 Probe Inductive Tracers
• Powered by standard 9 Volt Battery (not included)
• One Year Warranty

The Hound 3 Probe: Streamlined Inductive Tracer with Headlights and Earphone Jack

• New Headlights to help light your way in dark areas and reduce florescent light noise!
• Streamlined Design allows for better access in hard-to-reach areas
• New Shielded Design to suppress “Feedback Squeal”
• Bandpass Filter to suppress 60Hz and Hi Frequency Noise
• Earphone Jack for use in quiet or noisy environments
• Improved Sensitivity and Loudness
• Includes New Conductive Duck-Bill Tip for Safer, Easier Penetration in cable bundles - Metal tip also included
• Easy Access Battery Door
• Adjustable volume / sensitivity control
• LED gets brighter as the signal gets stronger - LED indication even works when Earphones are used!
• Contains a hi-gain, hi-impedance amplifier
• Capable of identifying the Fox’s tone up to 12 inches away
• Rugged, moisture resistant, mylar cone speaker
• Use with the Fox 2, Fox, Fox Jr., TDR, LAN TDR or WireMaster XR-2 for quick & efficient wire tracing
• Powered by a standard 9V battery (not included)
• One Year Warranty